Mettler Toledo IND570 Manuel D'installation page 54

2.4.5.3. IDNet Connections
The IND570 terminal supplies 12 V for the newer T-Brick type cell of the IDNet base. Older types of
IDNet bases (known as Pik or Pik-Brick) require both a 12 V and a 32 V supply. IND570 does not
support older IDNet bases that require a 32 V supply.
When using an IDNet version of the IND570 terminal, the cable connection from the base is made
to a connector (Figure 2-32) on the rear of the housing. The IDNet bases are supplied with a length
of cable and a connector that mates to the connector on the IND570 terminal.
Figure 2-33 shows the pin assignments and wire colors for the IDNet connector.
2.4.5.4. SICSpro Connections
The IND570 terminal supplies 12 VDC for SICSpro platforms. In the SICSpro version of the IND570
terminal, the cable connection from the platform is made to a connector (Figure 2-32) on the rear
of the IND570 housing. The SICSpro platforms are supplied with a length of cable and a connector
that mates to the connector on the IND570 terminal.
30205319 | 11 | 07/2019
Figure 2-32: IDNet Connector Location on the Harsh (left) and Panel (right) Enclosures
Figure 2-33: IDNet Connector Pin Assignments
IDNet connector
Pin Color
P1–A Green
P1–B Blue
P1–C Grey
P1–D Green
P1–E Red
P1–F White
P1–G
P1–H Pink
P1–J Yellow
P1–K Purple
P1–L Black
P1–M Orange
METTLER TOLEDO IND570 Terminal Installation Manual
Note
TXD+/RXD+
+30V
+12V
Jumper
RXD1+
RXD–
Ground
TXD–
TXD1–
TSD1+
RXD1–
2-21