Multifunction Switch Settings (Fig. 4, A); Setting The Flow Rate When Working With The Spray Lance (Fig. 4, B); Setting The Width Of The Spray Jet On The Spray Lance (Fig. 5) - WAGNER W 950 FLEXIO Mode D'emploi

W 950 Flexio W 950 Flexio
12.
Multifunction switch settings (fi g.
FILL/  Settings for cleaning and
CLEAN pre-fi lling the system
OFF  System is off
ON  Operating setting
When using the spray
i
attachment for varnish paints
and glazes, the FILL/CLEAN
functions may not be used!
13. Setting the fl ow rate when working with the spray
lance (fi g. 4, B)
The material quantity is set depending on the characteristics of the material (viscosity)
and the working speed of the operator.
This setting can be made variably with the material fl ow limiter:
lower material
higher material
We recommend starting with a low material fl ow setting and then gradually
i
adjusting this to suit needs. .
14. Setting the width of the spray jet on the spray lance
(Fig. 5)
A = wide spray jet
(black)
B = narrow spray
jet (white)
turn to the left

turn to the right

 For coating larger surfaces
 Working with a large fl ow
rate (black area on quantity
scale)
 For coating smaller areas,
corners and edges
 Working with a small fl ow
rate (white area on quantity
scale)
4, A)

A

A
GB D
Volume
B
B
41 41