WallPerfect W 995
WallPerfect W 995
11.
Multifunction switch settings (fig.
FILL/
Settings for cleaning and
CLEAN
pre-filling the system
OFF
System is off
ON
Operating setting
12. Setting the flow rate (fig. 3, B)
The material quantity is set depending on the characteristics of the material (viscosity)
and the working speed of the operator.
This setting can be made variably with the material flow limiter:
lower material
higher material
We recommend starting with a low material flow setting and then gradually
i
adjusting this to suit needs. .
13. Setting the width of the spray jet on the spray lance
(Fig. 4)
A = wide spray jet
(green)
B = narrow spray
jet (red)
turn to the left
turn to the right
For coating larger surfaces
Working with a large flow
rate (green area on quantity
scale)
For coating smaller areas,
corners and edges
Working with a small flow
rate (red area on quantity
scale)
3, A)
OFF
Fill/
CLEAN
A
A
GB
D
B
B
31
31