Error Type C - salmson SIE Série Notice De Montage Et De Mise En Service

11.3.3 Error type C

1
2
3
4
5
6
7
8
Fig. 47: Error type C, diagram
6.0.0.0
E000
6.0.0.0
- - -
3/6
6.0.0.0
300
5/6
6.0.0.0
6/6
Fig. 48: Acknowledge error type C
Installation and operating instructions SIE - DIE
E000 E000
12.3
S
E000 E000
12.3
S
0
12.3
S
Error type C (Fig. 47):
Program Contents
step/query
1 • Error code is displayed
• Motor off
• Red LED on
2 Error criterion fulfilled?
3 > 5 minutes?
4 • Error meter is increased
5 Error meter > 5?
6 • SSM is activated
7 Error acknowledged?
8 End; auto control is continued
Yes
No
If type C errors occur, proceed as follows to acknowledge (Fig. 48):
• To change to the menu mode, press the acknowledge button.
The menu number <6.0.0.0> flashes.
• Press the acknowledge button again.
The menu number <6.0.0.0> is displayed statically.
On the value display, "- - -" is displayed.
On the units display, the current incidence (x) as well as the maximum
incidence of the error (y) are displayed in the format "x/y".
After 300 seconds, the current incidence will be counted up by one.
NOTE
Once the cause of the error has been removed, the error will be auto-
matically acknowledged.
• Wait until the remaining time is up.
If the current incidence (x) is the same as the maximum incidence of
the error (y), this can be manually acknowledged.
• Press the acknowledge button again.
The error is acknowledged and the status page is displayed.
English
83