salmson SIE Série Notice De Montage Et De Mise En Service page 66

English
8.3 Explanation of standard symbols
Symbol Description
Constant speed
Constant control
e.g. Δp-c
or PID control
Variable control Δp-v
Input In2 (external setpoint)
activated
2
Access disable
BMS (Building Management System
PLR, LON) is active
DP/MP operating mode: parallel
operation
8.4 Symbols in graphics/instructions
Menu elements
Actions
60
The following symbols are shown on the display at the positions
shown above:
Symbol Description
Min operation
min
Max operation
max
Pump is running
Pump stopped
Pump runs in emergency operation
Pump stopped in emergency operation
DP/MP operating mode: main/reserve
The Section 8.6 "Operating instructions" on page 63 contains graph-
ics which should illustrate the operation concept and instructions for
making settings.
In the graphics and instructions, the following symbols are used to
simply illustrate menu elements or actions:
• Menu status page: the standard view on the display.
12.3
• "Level lower": a menu element, starting from which one can change
4.1.0.0
to a lower menu level (e.g. from <4.1.0.0> in <4.1.1.0>).
• "Information": a menu element which shows information about the
4.4.3.0
device status or settings which cannot be changed.
• "Selection/setting": a menu element which provides access to a
±
2.0.0.0
changeable setting (element with menu number <X.X.X.0>).
"Level higher": a menu element, starting from which one can change
to a higher menu level (e.g. from <4.1.0.0> in <4.0.0.0>).
Menu error page: in the event of an error, the current error number is
E000
displayed instead of the status page.
• Press tuning button: by pressing a tuning button, settings or menu
- +
numbers are increased or decreased.
• Press acknowledge button: by pressing the acknowledge button, a
menu element is activated or a change is confirmed.
• Navigate: carry out the handling instructions given below for navi-
gating in the menu up to the displayed menu number.
• Wait time: the remaining time (in seconds) is displayed on the value
display until the next state is reached automatically or manual input
can be made.
• Set DIP switch to the OFF position: set the DIP switch number "X"
ON
under the housing cover to the OFF position.
X
• Set DIP switch to the ON position: set the DIP switch number "X"
ON
under the housing cover to the ON position.
X
04/2009