Menu Elements Reference - salmson SIE Série Notice De Montage Et De Mise En Service

8.7

Menu elements reference

No. Description
1.0.0.0 Setpoint
2.0.0.0 Control mode
3.0.0.0 Pump on/off
4.0.0.0 Information
4.1.0.0 Actual values
4.1.1.0 Actual values
sensor (In1)
4.1.3.0 Power
4.2.0.0 Operating data
4.2.1.0 Operating hours
4.2.2.0 Use
Installation and operating instructions SIE - DIE
The following table gives an overview of the available elements of all
menu levels. The menu number and the element type are designated
separately and the function of the element is explained. If applicable,
there is information about the setting options of the individual ele-
ments.
NOTE
A few elements are hidden under certain conditions and are therefore
skipped in the menu navigation.
If, for example, the external setpoint adjustment at menu number
<5.4.1.0> is set to "OFF", the number <5.4.2.0> will be hidden. Only if
menu number <5.4.1.0> was set to "ON", the menu number <5.4.2.0>
will be visible.
The condition for hiding a menu element is explained in the last col-
umn of the table.
Type Symbol Values/explanations
±
Setting/display of the setpoint
(for further information, see
Section 8.6.1 "Adapting the set-
point" on page 63)
±
Setting/display of the control
mode
(for further information, see
Sections 9.4 "Setting the control
mode" on page 74 and 6.2 "Con-
trol modes" on page 50)
Constant speed
Constant control (p-c
Variable control (p-v
PID control
±
ON
Pump switched on
OFF
Pump switched off
Information menus
Display of current actual values
Depending on current control
mode.
(p-c, (p-v: Value H in mm
PID control: Value in %
Current power P in Watts
Display of operating data
Sum of the pump's active hours
of operation
(meter can be reset by infrared
interface)
Energy consumption in
kWh/MWh
English
Display conditions
Is not displayed for manual
control mode
67