salmson SIE Série Notice De Montage Et De Mise En Service page 70

English
8.6.2 Changing to menu mode
ON
2 s
1
12.3
Fig. 29: Standard menu mode
ON
2 s
1
12.3
Fig. 30: Service menu mode
E000
Fig. 31: Error case menu mode
8.6.3 Navigation
±
1.0.0.0
- +
±
2.0.0.0
- +
4.0.0.0 4.1.0.0
- + - +
5.0.0.0 4.2.0.0
- + - +
4.4.0.0
- +
Fig. 32: Navigation example
64
2 s
• While the display is showing the status page, press the acknowledge
±
2.0.0.0
±
5.0.0.0
±
6.0.0.0
2 s • Change to the menu mode (see 8.6.2 "Changing to menu mode" on
- +
• To select the menu element, press a tuning button.
• If the downward pointing arrow for "Level lower" is shown, press the
4.4.1.0
- +
4.4.3.0
• To return to the next higher menu level, select the "Level higher"
- +
To change to menu mode, proceed as follows:
button for 2 seconds (except in case of an error).
Standard behaviour: The display changes to menu mode. Menu
number <2.0.0.0> is displayed (Fig. 29).
Service mode: If service mode is activated via DIP switch 1 menu
number <5.0.0.0> is displayed first. (Fig. 30).
Error case: In case of error, menu number <6.0.0.0> is displayed
(Fig. 31).
page 64).
Carry out general menu navigation as follows (for an example, see
Fig. 32):
During navigation, the menu number flashes.
The menu number is incremented up or down. The symbol associated
with the menu element and the setpoint or actual value are shown, if
applicable.
acknowledge button in order to change to the next lower lever. The
new menu level is labelled on the display by the menu number, e.g.,
when changing from <4.4.0.0> to <4.4.1.0>.
The symbol for the menu element and/or the current value (setpoint,
actual value or selection) will be shown.
menu element and press the acknowledge button.
The new menu level is labelled on the display by the menu number,
e.g., when changing from <4.4.1.0> to <4.4.0.0>.
NOTE
If the acknowledge button is pressed for 2 seconds while a "Level
higher" menu element is selected, the display jumps back to the sta-
tus page.
04/2009