Operating Elements; Display Structure - salmson SIE Série Notice De Montage Et De Mise En Service

8 Operation
8.1

Operating elements

The touchpad
Fig. 22: Ackknowledge button
Fig. 23: Tuning buttons
DIP switch
ON
1 2
Fig. 24: DIP switch
8.2

Display structure

Installation and operating instructions SIE - DIE
The electronics module is operated using the following operating
elements:
Operating the touchpad:
• Pressing the acknowledge button (fig. 22)
• to select different menu levels
• to confirm/acknowledge inputs
• Pressing a tuning button (fig. 23)
• to select/alter a value
The tuning buttons are not identified!
The function depends on the orientation of the display
'+' increase value, forward:
always upper button
'-' decrease value, backward:
always lower button
The DIP switches (Fig. 9 Item 6/Fig. 24) are located under the housing
cover.
• Switch 1 is for switching between the standard and service mode.
For additional information, see Section 8.6.6 "Activating/deactivating
service mode" on page 66
• Switch 2 is for activating or deactivating the "access disable".
For additional information, see Section 8.6.7 "Activating/deactivating
access disable" on page 66
Information is shown on a display according to the following pattern:
1
4
2
5
max
min
4
2
Fig. 25: Display structure
Item no. Description
1 Menu number
2
Value display
3
Units display
NOTE
The display information can be rotated by 180°. To change, see menu
number <5.7.1.0>.
1 0 0 0
0 0
R P M
Item no. Description
Standard symbols
4
5
Symbol display
English
4
0
2
3
59