Personnel Qualifications - salmson SIE Série Notice De Montage Et De Mise En Service

1 General
About this document
2 Safety
2.1 Indication of instructions in the
operating instructions
Symbols:
Signal words:
2.2

Personnel qualifications

Installation and operating instructions SIE - DIE
These installation and operating instructions are an integral part of
the product. They must be kept readily available at the place where
the product is installed. Strict adherence to these instructions is a
precondition for the proper use and correct operation of the product.
These installation and operating instructions correspond to the rele-
vant version of the product and the underlying safety standards valid
at the time of going to print.
These operating instructions contain basic information which must
be adhered to during installation and operation. For this reason, these
operating instructions must, without fail, be read by the service tech-
nician and the responsible operator before installation and commis-
sioning.
It is not only the general safety instructions listed under the main
point "safety" that must be adhered to but also the special safety
instructions with danger symbols included under the following main
points.
General danger symbol
Danger due to electrical voltage
NOTE
DANGER!
Acutely dangerous situation.
Non-observance results in death or the most serious of injuries.
WARNING!
The user can suffer (serious) injuries. 'Warning' implies that (seri-
ous) injury to persons is probable if this information is disregarded.
CAUTION!
There is a risk of damaging the pump/unit. 'Caution' implies that
damage to the product is likely if this information is disregarded.
NOTE:
Useful information on handling the product. It draws attention to
possible problems.
The installation personnel must have the appropriate qualifications
for this work.
English
structions
ating
in-
and oper-
Installation
45