salmson SIE Série Notice De Montage Et De Mise En Service page 69

Error acknowledgement menu
Access disable menu
8.6 Operating instructions
8.6.1 Adapting the setpoint
- +
12.3
Fig. 28: Entering the setpoint
Installation and operating instructions SIE - DIE
• Only acknowledge errors after they have been remedied.
• Only have faults remedied by qualified personnel.
• If in doubt, consult the manufacturer.
1.0.0.0
- +
• Press a tuning button.
2200
RPM
• To confirm the change, press the acknowledge button.
1.0.0.0
1800
RPM
In the event of an error, the error page is displayed instead of the sta-
tus page. If the acknowledge button is pressed from this position, one
gets to the error acknowledgement menu (menu number <6.0.0.0>).
Those fault signals that are present can be acknowledged after a
waiting period.
Caution – material damage!
Errors which are acknowledged without their cause having been
remedied can result in repeated faults, which could lead to material
damage to the pump or system.
For additional information, see Section 11 "Faults, causes and
remedies" on page 78 and the error table shown there.
The main menu <7.0.0.0> is only displayed when the DIP switch 2 is in
the ON position. It cannot be reached via normal navigation.
In the "Access disable" menu, the access disable can be activated or
deactivated by pressing a tuning button. The change is confirmed by
pressing the acknowledge button.
On the status page of the display, the setpoint can be adapted as fol-
lows (Fig. 28):
The display changes to menu number <1.0.0.0>. The setpoint begins
to flash and is increased or decreased by continuing to press.
The new setpoint will be accepted and the display will return to the
status page.
English
63