salmson SIE Série Notice De Montage Et De Mise En Service page 76

English
No. Description
5.1.3.0 Pump cycling
5.1.3.1 Manual pump
cycling
5.1.3.2 Internal/external
5.1.3.3 Internal: time
interval
5.1.4.0 Pump enabled/dis-
abled
5.1.5.0 SSM
5.1.6.0 SBM
5.1.7.0 External off
5.2.0.0 BMS
5.2.1.0 LON wink/service
5.2.2.0 Local/remote
operation
5.3.0.0 In1 (sensor input)
5.3.1.0 In1 (sensor value
range)
5.3.2.0 In1 (value range)
5.4.0.0 In2
70
Type Symbol Values/explanations
±
Carries out pump cycling inde-
pendent of the countdown
±
Internal pump cycling
External pump cycling
±
±
Pump enabled
Pump disabled
±
Individual fault signal
Collective fault signal
±
Individual readiness signal
Individual run signal
Collective readiness signal
Collective run signal
±
Individual ext. Off
Collective ext. Off
Settings for Building Manage-
ment System (BMS) – building
automation
±
The wink function permits the
identification of a device in the
LON network. A "wink" is exe-
cuted by confirmation.
±
BMS local operation
BMS remote operation
Settings for sensor input
Display of the sensor value range Is not displayed with PID
±
Setting of the value range
Possible values: 0..10 V/2..10 V/
0..20 mA/4..20 mA
Setting for an external setpoint
input 2
Display conditions
Is only displayed in DP-MA
mode
Is only displayed in DP-MA
mode
Is only displayed in DP-MA
mode
Is only displayed in DP-MA
mode
Is displayed if internal pump
cycling is activated
Is only displayed in DP-MA
mode
Is only displayed in DP-MA
mode
Is only displayed for DP-MA
and SBM function readiness/
operation
Is only displayed in DP-MA
mode
Is only displayed in DP-MA
mode
Is only displayed in DP-MA
mode
Is only displayed in DP-MA
mode
Is only displayed in DP-MA
mode
Incl. all submenus, only dis-
played when BMS is active
Is only displayed in LON
operation
Incl. all submenus, not dis-
played in manual control
mode
control
04/2009