Safety Information; Disclaimer; Functions Of The Ets 3000 - HYDAC ELECTRONIC ETS 3000 Série Notice D'utilisation

4

1 Safety information

Before commissioning, check the instrument and any accessories supplied. Before
commissioning, please read the operating instructions. Ensure that the instrument is suitable
for your application.
If the instrument is not handled correctly, or if the operating instructions and specifications
are not adhered to, damage to property or personal injury can result.

2 Disclaimer

This operating manual was made to the best of our knowledge Nevertheless and despite the
greatest care, it cannot be excluded that mistakes could have crept in. Therefore please
understand that in the absence of any provisions to the contrary hereinafter our warranty
and liability – for any legal reasons whatsoever – are excluded in respect of the information
in this operating manual. In particular, we shall not be liable for lost profit or other financial
loss. This exclusion of liability does not apply in cases of intent and gross negligence.
Moreover, it does not apply to defects which have been deceitfully concealed or whose
absence has been guaranteed, nor in cases of culpable harm to life, physical injury and
damage to health. If we negligently breach any material contractual obligation, our liability
shall be limited to foreseeable damage. Claims due to the Product Liability shall remain
unaffected.
In the event of translation, only the original version of the operating manual in German is
legally valid.

3 Functions of the ETS 3000

The ETS 3000 is available with an integral sensor probe and with an external sensor probe.
The ETS 3000 features the following functions:
• Supports IO-Link specifications V1.1 and V1.0
• Supports SIO mode
• Display of the switching states in SIO mode
• Mode display (SIO or SDCI)
• Adaptation to the corresponding application using specific parameter settings
• Display of the actual temperature in °C or °F.
• Display of the lowest value, peak value or a set switching point
• Switching of the switching outputs in accordance with the temperature and the pre-set
switching parameters
• Analogue output
Edition: 2015-04-14
HYDAC ELECTRONIC GMBH
ETS 3000 IO-Link
Part No.: 669904