Operating Elements And Controls Of The Ets 3000; Digital Display - HYDAC ELECTRONIC ETS 3000 Notice D'utilisation

ETS 3000
5.

Operating Elements and Controls of the ETS 3000

HYDAC
°C °F
SP1
mode
Keys for setting the switching points,
switch-back points and
additional functions
6.

Digital Display

After switching on the supply voltage "ETS" appears briefly in the display, followed by the
actual temperature (basic setting).
The display can be changed as follows in the basic settings:
• Display of the peak value "
Continuously displays the highest or lowest temperature measured in the system since
switching the unit on or since the last reset.
• Display of the pre-set switching point: "
Continuously displays either switching point 1 or 2 depending on the model.
• Display is off: "
oFF"
The display is switched off.
• Depending on the setting, one of the following briefly appears in the display after
switching the unit on: "AcT", "ToP", "Min", "oFF", "S.P. 1", or "S.P. 2". It is possible to
display the actual temperature and "ToP" or "Min" briefly by pressing the
• When the Display actual temperature setting option is selected, you have the option of
displaying the lowest or peak value by pressing the
3 seconds.
The lowest and peak value can be reset in any display mode by briefly pressing the
and keys simultaneously. This is confirmed by r
Notes:
• If the actual temperature exceeds the unit's rated temperature, it can no longer be
displayed and the display will start to flash.
Status 17.08.2016
Indication of the
temperature scale
4-digit
digital display
SP2
LED for the
active switching point
3 s
or lowest value "
ToP"
S.P. 1"
HYDAC ELECTRONIC GMBH
3 s
Min"
, "
S.P. 2"
or key. This is then displayed for
appearing in the display.
ES
Page 5
or key.
Part No.. 669859