Errors / Causes / Troubleshooting - Winkhaus blueMotion Instructions D'installation

Installation, Operating and
Maintenance Instructions
6 Errors / Causes / Troubleshooting
CAUTION! If the power supply has been interrupted, system
errors are possible! As soon as power is sapplied again, the
system adjusts itself (reference travel). To avoid interference,
we recommend the battery with charging connection.
Error / Display
n n n n
4 x short acoustic
signal
The locking has
taken place, but
sluggish and can
be damaged in the
long term.
Notice: The locking
is still working
properly.
Aug. Winkhaus GmbH & Co. KG ∙ Berkeser Straße 6 ∙ 98617 Meiningen
T +49 369 3950 - 0 ∙ www.winkhaus.de ∙ Subject to technical changes
blueMotion
Possible cause
e.g.:
• opening / locking
mechanism is too
stiff
• door can be
warped
• door sash
hanging
• improper installa-
tion
87
Troubleshooting
• check for proper door instal-
lation (e.g. airgap)
• re-adjust the door (e.g.
re-adjust adjustable keeps,
tighten, adjust hinges)
CAUTION!
Warning signal (4 x short) is
sounded up to 10 x in sequence
in case the locking is not
smooth, whereupon, the
motor-driven locking is locked,
to protect the system from
permanent overloading.
After the locking, if an electrical
actuation is attempted, there is
a short beep for about
5 seconds (30 x).
After eliminating the error cau-
se the electrically locking can
be reseted. For this, press the
button for resetting the error
counter for at least 6 seconds.
An acoustic signal confirmes
this process (reset of the error
counter)!
Important: The error counter is
blank, but if necessary not
cause of error.
5044745
EN
6