Winkhaus blueMotion Instructions D'installation page 189

Installation, Operating and
Maintenance Instructions
Teaching-in via the wireless receiver (part no.: 2142897)
Notice: The teaching-in per remote control is not possible for
this receiver!
The wireless receiver saves the keys of the wireless remote control in the
sequence entered.
• To teach-in, press the P1 key of the circuit board of the wireless receiver.
• The green LED will light up.
• Release the P1 key.
• Then press the key of the wireless remote control you would like to save.
• The green LED goes out.
• The desired key of the wireless remote control has been taught.
Deleting via the wireless receiver
Partial deleting
• Press and hold the P1 key for about 2 seconds.
• When the green LED lights up, release the P1 key.
• Press the key of the wireless remote control you would like to delete.
• Deleting the key is indicated by the flashing LED.
Delete-all
• Press and hold the P1 key until the green LED lights up.
• Release the P1 key.
• While the LED is lit, press the P1 key again until both LEDs flash tree times.
The memory is full once 85 keys have been saved in the wireless remote cont-
rol. No additional wireless remote control can be saved. This is indicated in the
teach-in mode by both LED displays flashing simultaneously three times.
Aug. Winkhaus GmbH & Co. KG ∙ Berkeser Straße 6 ∙ 98617 Meiningen
T +49 369 3950 - 0 ∙ www.winkhaus.de ∙ Subject to technical changes
blueMotion 85 5044745
EN
4