Winkhaus blueMotion Instructions D'installation page 151

Installation, Operating and
Maintenance Instructions
Installation of external control unit with acoustic signal indicating
free / open / accessible
Figure 3.4-5: Installation external control unit with acoustic signal
Caution! Please note that the relay output with max. 30 W at
30 V max. 1 A may be charged.
This is not on output for the alarm system, because the
mechanical locking modus is not monitored, this must be done
by a deadbolt switch contact (RSK)!
Installation sequence
• Prior to installing the blueMotion unit, connect the sash cable of the cable
transition "T-KÜ-T1 FT ..." or "T-Anschlusskabel ..." to the motor housing.
• Run the cable to the switch boxes.
Notice: These switch boxes should be mounted on the interior,
in close proximity to the entryway door!
• The external control unit should preferably be housed in a 65 mm deep flush-
type box.
• In the very same flush-type box, you can install the button to unlock the door
from the inside.
Aug. Winkhaus GmbH & Co. KG ∙ Berkeser Straße 6 ∙ 98617 Meiningen
T +49 369 3950 - 0 ∙ www.winkhaus.de ∙ Subject to technical changes
blueMotion
signal
transmitter
e.g. Piezo
(insert any resistor)
47 5044745
The buzzer indicates that
the door is open, until it is
closed again.
The circuit is made via
the output swing door
drive (Terminals 6 - 8).
EN
3