Access Control System Wireless Remote Control; Wireless Remote Control Set - Winkhaus blueMotion Instructions D'installation

Installation, Operating and
Maintenance Instructions
• Connect the cable of the antenna (fixed in the antenna) to the external
control (terminals 15 + 16).
• We recommend: Run a reserve pipe from the antenna to the external control unit.

3.6 Access control system wireless remote control

Prerequisites for installation
• Proper positioning of the wireless receiver is of utmost importance to ensure
its reliable performance.
• Do not install it at or nearby sources of possible interference (e.g. EDP / high-
performance power distributor).
• We recommend installing the receiver on the protected inside of the door to
prevent manipulations to the receiver!

3.6.1 Wireless remote control set

Installation sequence
• The wireless receiver should preferably be installed in a 65 mm deep flush-
type box on the inside.
Notice: If use the flush-type box of the "day / night service"
switch, the box will have to be 65 mm deep!
• Unless use a switch or button beside the door, will have to provide a switch
box with a filler panel for the wireless receiver and the external control unit.
Notice: For safety reasons, you are not permitted to install it
in a flush-type box with a 230 V AC switch or socket outlet.
• Connect the terminals 2 - 5 of the wireless receiver with the external control
unit as described in the following table:
Aug. Winkhaus GmbH & Co. KG ∙ Berkeser Straße 6 ∙ 98617 Meiningen
T +49 369 3950 - 0 ∙ www.winkhaus.de ∙ Subject to technical changes
blueMotion 53 5044745
EN
3