Wireless Receiver For Additional Applications (E.g. Garage Door Control Units) - Winkhaus blueMotion Instructions D'installation

Installation, Operating and
Maintenance Instructions
EN
Delete-all
• Press and hold the P1 key of the receiver until the green LED lights up.
• Release the key.
• Press the key again until the green and red LED flash three times.
• All wireless remote control have been deleted now.
ON / OFF modality
4
• The default setting of the relay of the receiver is "Pulse".
• For additional applications you can program it as an ON / OFF relay
(specified by the respective application).
• Press and hold the P1 key of the receiver until the green LED lights up.
• Release the key.
• Press P1 again.
• The LED flashes and the relay is switched to the ON / OFF function.
• Use the same procedure to get to the pulse mode.
• The LED will then be lit continuously.
Displaying the occupied memory units
• Press and hold the P1 key of the receiver until the green LED lights up.
• Press and hold until the LED goes off.
• Then release the key immediately.
The display is a binary code. LED green = 1, LED red = 0
4.4 Wireless receiver for additional applications
(e.g. Garage door control units)
Aug. Winkhaus GmbH & Co. KG ∙ Berkeser Straße 6 ∙ 98617 Meiningen
T +49 369 3950 - 0 ∙ www.winkhaus.de ∙ Subject to technical changes
blueMotion 84 5044745
No. Name
JP1 jumper
P1 button
K4 relay
red LED
green LED