Wiring A Version With Transistor Output And En175301-803 Male Fixed Connector - Burkert 8032 Manuel D'utilisation

Masquer les pouces Voir aussi pour 8032:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Unscrew the nut [1] on the body [4].
4
3
2
1
Insert the cable into the nut [1], the cable
clamp [2] and the seal [3], and then into
the body [4].
Strip 20 mm of the cable.
5
Cut the central wire (earth) so that its
length is equal to 11.5 mm.
Expose 5.5 mm of the wires on the
stripped cable.
Insert each wire into the appropriate pin
on the terminal block [5] (see chap. 7.3.3
to 7.3.7).
Screw the terminal block [5] once wired
to the body [4]
Tighten the connector nut [1].
Fig. 11:
Assembling an M12 female connector (not supplied )
18
English
installation and wiring
Installationandwiring
7.3.2.
Wiring a version with transistor
output and en175301-803 male fixed
connector
danger
risk of injury due to electrical voltage
• Always plug in and tighten the connectors correctly.
the device is not tight when the en 175301-803 fixed
connector is not wired:
Unscrew the nut [1] (see Fig. 10) on the 2508 female
connector supplied with the device.
Insert the plug with order code 444509, supplied with
the device, into the cable gland.
Screw the nut again.
Plug the sealed 2508 connector onto the
EN 175301-803 fixed connector.
1
2
1
2
3
3
Fig. 12:
Pin assignment of the EN175301-803 fixed connector
1: V+ (12-36 V DC)
2: Transistor output (NPN or PNP)
3: 0 V DC
4: Functional earth

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

8072

Table des Matières