Choosing The Output Wiring Mode; Setting The Probe Parameters Of The 8202; Activating/Deactivating The Hold Function - Burkert ELEMENT 8202 Mode D'emploi

Ph/redox-mètre ou conductivimètre
Masquer les pouces Voir aussi pour ELEMENT 8202:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Type 8202/8222
Adjustmentandcommissioning
9.7.
choosing the output wiring
mode
The setting has no effect on a version with one fixed
connector, if the sole current output is wired.
Param
Outputs
This is
This is
when the
device is be-
when the
ing parame-
device is be-
tered............
ing parame-
....................
tered............
....................
9.8.
setting the probe parameters of
the 8202
The monitoring of the redox ("ORP") sensor is impossible if
the measurement mode is set to "asymmetrical".
Param
Sensor
This is
This is
when the
when the
device is be-
device is be-
ing parame-
ing parame-
tered............
tered............
....................
....................
HWMode
source/PNP
sink/NPN
Type:
pH
ORP
Mode:
Symmetric
Asymmetric
Mains Fcy:
50Hz
60Hz
9.9.
Activating/deactivating the hold
function
The Hold mode is automatically deactivated when the trans-
mitter restarts after a power interruption, if the Hold mode
was activated at the moment of the power cut-off.
Calib
System
English
Hold
Hold:Disable
Hold:Enable
35

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Element 8222

Table des Matières