Checking The Samples During The Washing Procedure Or Production Of The Suspension; Performing Centrifugation Run With Spin Centrifugation Program; System With Rinsing Cleaning Program (Clean Program) - Hettich ROTOLAVIT Mode D'emploi

•
After production of the suspension termination or through pressing the
fixed braking level. The braking level is displayed.
Display when rotor is stationary:
PROG CYC t/ min:s
ml RPM
Man. SUSP. DONE
15.2.4

Checking the samples during the washing procedure or production of the suspension

The washing procedure and the production of the suspension can be interrupted for checking the samples.
•
Press the button. The LED in the
CHECK
Display when rotor is stationary:
PROG CYC ml RPM t/ min:s
OPEN LID
•
Open the lid and check the tubules.
•
Close the lid again and press the
suspension.
15.2.5

Performing centrifugation run with Spin centrifugation program

•
Load the rotor and close the centrifuge lid.
•
With the or key select the Spin program position.
The centrifugation data of the Spin program position is displayed.
•
Press the button. The rotation indicator
SPIN
The time only begins to count after the set rotation speed is reached.
Spin and briefly SPIN are displayed.
PROG CYC t/ min:s
ml RPM
1 Spin 3000 SPIN
•
After the time has elapsed or after the centrifugation cycle has been interrupted by pressing the
ends with a fixed braking level. The braking level is displayed.
Display when rotor is stationary:
PROG CYC ml RPM t/ min:s
OPEN LID
The rotation speed of the rotor and the time remaining is displayed during the centrifugation cycle.
15.2.6

System with rinsing cleaning program (Clean Program)

Rinsing out the system:
•
Device without 3-way valve:
Take off the supply hose from the physiological saline solution container and connect it to a container which is
filled with distilled water.
Device with 3-way valve:
Turn the 3-way valve to the "H
on the "3-way valve".
•
Load every second rotor position with an empty tube and close the centrifuge lid.
If every second rotor position is loaded with an empty tube then the drain gutter is also rinsed out with
distilled water.
•
With the or key select the Clean Program program position.
•
Press the key. The rotation display
START WASH
1. Filling the destilled water.
The LED in the
SALINE
Clean and FILL is displayed.
PROG CYC ml RPM
Clean 1100
2. Centrifugation run.
Clean and SPIN is displayed.
PROG CYC ml RPM
Clean 1500
key illuminates.
CHECK
key to continue with the washing procedure or the production of the
START WASH
lights up as long as the rotor is turning.
O" position so that the system is connected to the distilled water; see the chapter
2
illuminates as long as the rotor is turning.
key illuminates whilst the distilled water is injected in.
t/ min:s
FILL
t/ min:s
SPIN
key the run-out is performed with a
STOP
STOP
EN
button, it
55/130