Hettich ROTOLAVIT Mode D'emploi page 56

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

EN
3.
Decanting.
Clean and DCNT is displayed.
PROG
CYC
ml
RPM
Clean
600 DCNT
4.
Shaking.
Clean and AGIT is displayed.
PROG
CYC
ml
RPM
Clean
0
5.
Decanting.
Clean and DCNT is displayed.
PROG
CYC
ml
RPM
Clean
600 DCNT
After completion or after termination of the cleaning program by pressing the
with the fixed braking level. The braking level is displayed.
Display with stationary rotor:
PROG
CYC
ml
RPM
t/ min:s
OPEN LID
Open the lid.
Display after completion of the cleaning program:
PROG
CYC
ml
RPM
t/ min:s
Clean proc. DONE
If the cleaning program is terminated with the
display appears:
PROG
CYC
ml
RPM
t/ min:s
Clean Program
The cleaning program must be started again.
Switch the unit OFF.
Filling the system:
Device without 3-way valve:
Take off the supply hose from the distilled water container and connect it again to the physiological saline
solution container.
Device with 3-way valve:
Turn the 3-way valve to the "NaCl" position so that the system is connected to the physiological saline solution;
see the chapter on the "3-way valve".
Switch the unit ON
Display:
PROG
CYC
ml
RPM
t/ min:s
Clean proc. DONE
If
OPEN LID
Hold a container with a capacity of at least 80 ml in front of the injection pipe in order to catch the distilled water.
Then press and hold the
If a different key than the
PROG
CYC
t/ min:s
ml
RPM
Press 3s SALINE
The system is filled with saline solution.
Display:
PROG
CYC
ml
RPM
t/ min:s
Refill process
56/130
t/ min:s
t/ min:s
AGIT
t/ min:s
key before the distilled water was decanted the following
STOP
is displayed open the lid.
key for 3 seconds.
SALINE
key is pressed the following display appears:
SALINE
key the run-out is performed
STOP

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

10061006-01

Table des Matières