Programming; Global Parameters Adjustment; Entering Spin Centrifugation Program; Entering Program Parameters - Hettich ROTOLAVIT Mode D'emploi

14

Programming

14.1

Global parameters adjustment

The adjustment of the global parameters has an effect on the program parameters for programs 1 to 5.
If after the selection or during input of global parameters a key is not pressed for 16 seconds then the previous
values will be displayed on the display again. The adjustments performed up to this moment in time are
automatically saved. If the adjustments are not to be saved the device must be switched OFF during the 16
seconds.
•
Hold the button down for 8 seconds.
After 8 seconds VOLUME ADJUST XX appears in the display.
•
Select the desired parameter with the key
To select the parameter ShakeT (min), set the parameter Shakings with the key
•
Press the key
START WASH
displayed as confirmation, after pressing the
14.2

Entering Spin centrifugation program

On the Spin (S) program location a centrifugation program can be entered. In this program only the speed and the
running time can be adjusted.
If after the selection or during input of program parameters a key is not pressed for 16 seconds then the
previous values will be displayed on the display again. The adjustments performed up to this moment are not
automatically saved. The input of parameter then has to be executed again.
The input of the program parameters can be terminated at any time by pressing the
the adjustments are not saved.
•
With the or key select the Spin program position.
The centrifugation data of the selected program position is displayed.
•
Select the desired parameter with the key
• key to save the adjustments to the S program position. As confirmation, ∗∗∗ ok ∗∗∗ will be
Press the
START WASH
displayed for a short period.
The previous data for the program position is overwritten when it is saved.
14.3

Entering program parameters

If after the selection or during input of program parameters a key is not pressed for 16 seconds then the
previous values will be displayed on the display again. The adjustments performed up to this moment are not
automatically saved. The input of parameter then has to be executed again.
The input of the program parameters can be terminated at any time by pressing the
the adjustments are not saved.
•
For adjustment of the global parameters refer to chapter "Globale Parameter einstellen".
•
Select the desired parameter with the key
•
Select the parameter PROG with the key
LED in the key lights up.
PROG
•
Press the key
START WASH
∗∗∗ ok ∗∗∗ will be displayed for a short period.
The previous data for the program position is overwritten when it is saved.
, and adjust with the keys
or to save the adjustment. After pressing the
STOP
key no confirmation is given.
STOP
, and adjust with the keys
, and adjust with the keys
, and set the desired programme position with the keys
in order to store the adjustments to the desired programme position. As confirmation,
.
to smaller than "0".
key ∗∗∗ ok ∗∗∗ is briefly
START WASH
key. In this case
STOP
.
key. In this case
STOP
.
EN
. The
47/130