Run-Up And Run-Down Parameters; Run-Up Step; Braking Step; Brake Switch-Off Speed - Hettich ROTINA 380 Mode D'emploi

15.5

Run-up and run-down parameters

15.5.1

Run-up step


Press the key as often as necessary until the parameter

Use the adjusting knob

If necessary, press the

To apply the setting to the display, either press the
the centrifugation data are displayed.
15.5.2

Braking step

B-braking stages can only be set in combination with special rotors.
The B-braking stages can only be set if this is activated. See chapter "Activate or deactivate B-braking
stages".

Press the key as often as is required until the parameter

Use the adjusting knob
The B-braking stages are displayed after braking stage 9.

If necessary, press the

To apply the setting to the display, either press the
the centrifugation data are displayed.
15.5.3

Brake switch-off speed


Press the key as often as necessary until the parameter N Brake is shown.

Use the adjusting knob

Press the or
START
15.6

Temperature (only for centrifuge with refrigeration)

The temperature can be entered in degrees Celsius (°C) or in degrees Fahrenheit (°F). For setting the
temperature unit, see chapter "Set temperature unit".

Press the key. The following parameters are displayed: T/°C or T/°F.
T/°C

Use the adjusting knob

Press the key, to have the settings applied to the display.
START

Press the or
T/°C START
16

Programming

If parameters are changed, the program place number is displayed in parentheses (). This means that the
centrifugation data in the display no longer corresponds to the centrifugation data from the program place that
has been saved.
to set the level you want.
key to set the next parameter.
START
to set the level you want.
key to set the next parameter.
START
to set the value you want.
keys to apply the setting to the display.
to set the value you want.
keys to apply the setting to the display
is shown.
key or press the key as often as is required until
or is displayed.
key or press the key as often as is required until
EN
53/165