EN
14.3.2
Relative centrifugal force (RCF)
The relative centrifugal force (RCF) depends on the radius of the centrifuge. Before setting the RCF, the
radius of the centrifuge must be set. See chapter "Centrifuge radius (RAD)".
•
Keep pressing the
RCF
The LED is lit in the key.
•
Use the adjusting knob
•
Press the
key, to have the settings applied to the display.
START
14.4
Run-up and run-down parameters
14.4.1
Run-up step
•
Press the
key as often as necessary until the parameter
•
Use the adjusting knob
•
Press the
key, to have the settings applied to the display.
START
14.4.2
Braking step
•
Press the
key as often as necessary until the parameter
•
Use the adjusting knob
•
Press the
key, to have the settings applied to the display.
START
14.4.3
Brake switch-off speed
•
Press the
key as often as necessary until the parameter N Brake is shown.
•
Use the adjusting knob
•
Press the
key, to have the settings applied to the display.
START
14.5
Temperature
The temperature can be entered in degrees Celsius (°C) or in degrees Fahrenheit (°F). For setting the
temperature unit, see chapter "Set temperature unit".
•
Press the
key. The following parameters are displayed: T/°C or T/°F.
T/°C
•
Use the adjusting knob
•
Press the
key, to have the settings applied to the display.
START
15
Programming
If parameters are changed, the program place number is displayed in parentheses (). This means that the
centrifugation data in the display no longer corresponds to the centrifugation data from the program place that
has been saved.
15.1
Inputting or changing programs
•
Set the parameters you want (see chapter "Enter centrifugation parameters").
•
Press the
key as often as necessary until the STO parameter is shown.
PROG
•
Use the adjusting knob
If a "+" is shown after the program location, then this data is write-protected. In this case, the write
protection has be removed first before saving (see the chapter on "Write protection for programs").
•
Press the
key to have the settings saved to the program place you want. Briefly, Program store ... is
START
displayed as confirmation.
The previous program location data will be overwritten when the new data is saved.
If "Protected !!" is displayed, then the data at the program location is write-protected and it will not be
saved.
42/108
key until the parameters RCF and RAD are displayed, e.g. RCF = 3695 RAD = 146.
to set the RCF you want.
to set the level you want.
to set the level you want.
to set the value you want.
to set the value you want.
to set the program place you want.
is shown.
is shown.