HBK U10M Notice De Montage page 62

Index Sub-
(hex) index
(hex)
0x0203 0x00
0x0055 0x00
0x0056 0x00
0x0057 0x00
0x0058 0x00
0x005E 0x00
0x005F 0x00
8.2.2.9 Alarms (IO-LINK events)
The electronics monitors the sensor and continuously compares the mechanical and ther­
mal stresses against the limit values of the force transducer. With thermal monitoring,
they are also compared against the limit values of the electronic components.
The electronics uses a very high sample rate to evaluate the mechanical stress.
Even very short force peaks are recorded, and a notification is given if the limit values
are exceeded. As the output of measurement values via the IO-Link connection runs at
a lower sample rate, it may be that you cannot find a force value registered as a force
overshoot in the transferred measurement data.
60
Authoriza­ Data type
tion
Read/ UInteger8T
Write
ReadOnly Float32T
ReadOnly Float32T
ReadOnly Float32T
ReadOnly Float32T
ReadOnly Float32T
ReadOnly Float32T
Data Name
size
(bytes)
1 Nominal
Tempera­
ture
Overload
Warning
4 Transducer
temperature
4
4
4
4 Hysteresis
for resetting
temperature
4
warnings
Description
Enables/
disables
warnings when
the tempera­
ture exceeds/
falls below the
nominal (rated)
temperature of
the sensor.
0x00 = Disable
0x01 = Enable
Nominal (rated)
temperature
upper limit
Nominal (rated)
temperature
lower limit
Operating
temperature
upper limit
Operating
temperature
lower limit
Upper limits
Lower limits
U10M
ELECTRICAL CONNECTION