Publicité
4. Calibration
On request, HBK can calibrate the force transducer to 200% nominal (rated) force.
The high mechanical reserves of the force transducer make this application possible
in measurement tasks with a limited oscillation bandwidth (see Specifications).
But be aware that when double the force is measured, the output signal also doubles.
100% (dyn.)
200% (stat.)
5. TEDS
You can purchase the force transducer with transducer identification ("TEDS chip").
A TEDS (Transducer Electronic Data Sheet) chip allows you to store the transducer
data (rated outputs) in a chip, which can be read by a connected measuring device.
In the double-bridge version, each measuring bridge has a dedicated TEDS chip.
See also page 64. TEDS chips are not available together with amplifier modules.
With TEDS
Without TEDS
6. Mechanical design
You can purchase the force transducer without an adapter. The force transducer can
then be directly screwed onto a structural element using the pitch circle, see Fig. 3.1.
With adapter
Without adapter Code N
Fig. 3.1
U10M with adapter (left) and without adapter (right)
7. Plug protection
On request, we can fit plug protection, consisting of a strong square tube (round tube
for nominal (rated) force 1.25 MN), so that the plug is protected against mechanical
damage.
Without
With
U10M
SCOPE OF SUPPLY, CONFIGURATIONS, ACCESSORIES
Code 1
Code 2
Code T
Code S
Code W
Code U
Code P
9
Publicité
