Publicité
Where the switch is to be triggered on a falling force:
u
Switch the logic to "Low active".
u
Set the "SP1" field to the higher force (in the logic defined above).
u
To make the new switchover on a falling force at a lower force value, enter the lower
force value in SP2. If you set both values the same, the switch will work without hys
teresis.
Window mode
The range can be monitored in Window mode.
S
Enter the two forces that define the switching points, SP1 and SP2. Their order is irrel
evant.
S
If you want, you can enter an identical hysteresis for the upper and lower switching
points.
S
You can invert the output by selecting "High active" or "Low active". When "High active"
is selected, the output is logical 1 if the value is in the window range.
The state of the limit value switch can be outputted via two digital outputs in the form of
a 24 V switching signal in the electronics.
Index
Sub-
(hex)
index
(hex)
0x003C 0x00
0x003C 0x01
0x003C 0x02
0x003D 0x00
46
Authorization
ReadWrite
ReadWrite
ReadWrite
ReadWrite
Data type
Data
size
(bytes)
RecordT
8
Float32T
4
Float32T
4
RecordT
6
Name
Description
SSC1
Access all
Param
parameters
(SP1, SP2)
for Switching
Channel 1
SSC1 SP1
Switching
point for
Switching
Channel 1
SSC1 SP2
Second
switching
point for
Switching
Channel 2
SSC1
Access all
Config
configurations
for Switching
Channel 1
ELECTRICAL CONNECTION
U10M
Publicité
