Publicité
0x0002
0x00
0x003B
0x01
8.2.2.7.7 Assignment of digital switching outputs ("Digital IO")
The DO connection (pin 2, see above) is always available as a digital output. The C/Q/SIO
connection (pin 4, see above) can only be used as a digital output if IO-Link data transfer
is not required at the same time.
You can output the status of the limit value switches as digital IO with a switching voltage
of 24 V (max. 50 mA). If you want to do this, you must assign a limit switch to the digital
switching outputs. To do so, open the "Digital IO" menu.
S
"DO pin function" determines which limit value switch is assigned to pin 2 on the plug.
This digital output is always available when the device is in operation.
S
"C/Q pin function in SIO-mode" determines which limit value is assigned to pin 4 on the
plug when the device is operated in SIO mode. SIO mode means that the force mea
surement chain is not connected to an IO-Link master, or that the IO-Link master is
being operated in SIO mode. The force measurement chain automatically switches to
this operating mode if no IO-Link connection is initiated by a master. Note that in this
operating state there are two switching outputs, but no other measurement or process
data is transferred.
S
The "Permanent high", "Permanent low" and "Limit switch 1" and "Limit switch 2"
options are available for both outputs.
U10M
ELECTRICAL CONNECTION
WriteOnly
UIntegerT
ReadOnly
1 byte
System
command
4 bits
Result
(Success or
Error)
Trigger
teach-in
0x41=Teach
SP1
0x42 =
Teach SP2
Confirmation
that the
teach-in
process is
OK
49
Publicité
