HBK U10M Notice De Montage page 40

Index Sub­
(hex) index
(hex)
0x0C46 0x00
0x0C47 0x00
0x0C26 0x00
Linearization via supporting points
u
Select "Stepwise linear Adjustment"; the "Adjustment supporting points" menu is dis­
played. Open this menu.
u
Enter the number of supporting points, between 2 and 21. Note that the zero point is a
supporting point. So if you want to enter a straight line, select two supporting points.
("Adjustment Number of Supporting Points" menu item).
u
Under "Adjustment X" enter the force preset by the calibration system. Under "Adjust­
ment Y" enter the measurement result shown in the calibration certificate that corre­
sponds to the respective force.
u
It is important to start with the most negative force, as that is the highest tensile force.
On compressive force-only sensors , 0 N is defined as the "highest tensile force".
38
Authorizat­ Data type
ion
ReadWrite StringT
ReadWrite StringT
ReadWrite UIntegerT
Data Name
size
(bytes)
32 Certificate
ID
32 Certificate
Expiration
Date
1 Lineariza­
tion Mode
Description
Number of the
calibration
certificate
Date on which a
new calibration
is required
Selection of the
linearization
method:
0: No lineariza­
tion is applied
1: Linearization
via supporting
points
2: Linearization
via cubic
function
U10M
ELECTRICAL CONNECTION