Publicité
PDin: All process data sent from the sensor to the master is shown here.
MDC – Measurement Value:
Operation force exceeded
SSC.1.Switching Signal
SSC.2.Switching Signal
PDout: All process data sent from the master to the sensor is shown here.
Zero Reset
Zero Set
CSC – Sensor Control
34
Current measured value
Indicates when the operating force range is exceeded
Status of limit value switch 1
Status of limit value switch 2
"False" means zeroing is on; "True" means the zero value
in the memory is ignored, zeroing is not possible.
Triggers zeroing. Zeroing is carried out when the bit is
switched from "false" to "true" (rising edge). To a new
zero reset, the bit must first be switched back to "false".
Replaces the measured value with a fixed feed value.
U10M
ELECTRICAL CONNECTION
Publicité
