Panasonic SD-YR2540 Mode D'emploi page 68

Problem
When making jam, can we
use fruits are pickled in
alcohol?
The fruit has collapsed when
making compote.
The kneading blade rattles.
I can smell burning while the
bread is baking.
Smoke is coming out of the
steam vent.
Dough leaks out from
bottom of the bread pan.
"1" appears on the display
and operation has been
stopped.
"H01", "H02" appears on the
display.
"U50" appears on the display.
OI5 SD-YR2540 EU Pagination ——3rd_20201210.indd 23
During or after cooking
 Do not use them. The quality is not satisfactory.
 The cooking time was too long. The fruit may have been over ripe.
Puzzle
 This is because the kneading blade fits loosely on the kneading mounting shaft. (This is not a fault.)
 Ingredients may have been spilt on the heating element.
→ Sometimes a little flour, raisins or other ingredients may be flicked out of the bread pan during
mixing. Simply wipe the heating element gently after baking once the machine has cooled down.
→ Remove the bread pan from the main unit to place ingredients.
 A small amount of dough will escape through the ventilation holes (so that it does not stop the
rotating parts from rotating). This is not a fault, but check occasionally that the kneading mounting
shaft rotate properly.
→ If the kneading mounting shaft does not rotate when the kneading blade is attached, you will need to
replace the kneading mounting shaft unit. (Consult the place of purchase or Panasonic service centre.)
(Bottom of bread pan)
Ventilation holes (4 in total) Kneading mounting shaft
Display exception
 When the power supply to machine is interrupted for a certain time, the display shows "1" after
recovered. (It is standby mode and machine could not continue the program.)
→ Remove the bread, dough or ingredients and start again using new ingredients.
 The display indicates a problem with the machine.
→ Consult the place of purchase or a Panasonic service centre.
 The machine is hot (above 40 °C). This may occur with repeated use.
→ Allow the machine to cool down to below 40 °C before using it again (U50 will disappear).
Cause and Action
Kneading
mounting shaft
Kneading
mounting shaft unit
Part no. ADA29E1651
GB23
2021/2/6 上午 09:59:03