Angelo Po AMERICA FX61 G 2 Manuel D'utilisation page 9

SAFETY LABELS AND SIGNS
A 1 Water specications (Hardness, pH, Conductivity)
2 Equipotential terminal
3 Read the manual
4 This equipment is to be installed to comply
with the applicable Federal, state, or local
plumbing codes having jurisdiction.
5 DANGEROUS VOLTAGE
B WATER DRAIN
C Wiring diagram
D Leave the door ajar once the cooking cycle and
cleaning operations have terminated
E
Caution: hot surfaces
F
Caution: very hot steam
G Warning: Improper installation, adjustment
alteration, service or maintenance can cause
property damage, injury or death. Read
the installation operating and maintenance
instructions thoroughly before installing or
servicing the equipment; This appliance is for
use only with the specifi c legs or base provided;
Intended for other than household use.
CLEARANCE: BACK / 0 inches / LEFT SIDE
19.7" inches (500 mm) - RIGHT SIDE 7.8"
inches (100 mm); All clearance are the same
for combustible and non-combustible location;
Suitable for installation on combustible fl oors;.
CAUTION:
DISCONNECT
SUPPLY BEFORE SERVICING. Cooking chamber
convection fan can rotate in a clockwise and anti-
clockwise direction.
H) WARNING: This appliance is for use only with
L) CAUTION: To reduce the risk of electric
M) NAME PLATE
N) WARNING: Type and rating of fuse
O) NOTICE: When this appliance is installed with
P) SWITCHING THE APPLIANCE ON AND OFF
THE POWER
Combination Oven Installation and Operation Manual
the specifi c fl ue chimney provided; For installation
under ventilation hood only; This appliance can
be used with propane gas and natural gas. It is
shipped from the factory adjusted for use with
natural gas; Not suitable for connection to type
B gas vent; For your safety refer to installation
instructions for conversion procedure.
shock, do not remove or open cover. No user-
serviceable parts inside. Refer servicing to
qualifi ed personnel.
Use supply wires suitable for 75°C (167°F).
Use copper wire only for power-supply connections
casters, it must be installed with the casters
supplied, a connector complying with either
ANSI Z21.69 • CSA 6.16 and a quick-disconnect
device complying with ANSI Z21.41 • CSA
6.9. It must also be installed with restraining
means to guard against transmission of strain
to the connector, as specifi ed in the appliance
manufacturer's instructions.
Section 1
Safety Precautions
9