Angelo Po AMERICA FX61 G 2 Manuel D'utilisation page 46

Section 7
Parts Replacement
REPLACING THE FUSE
WARNING Before performing any service
that involves electrical
disconnection and/or exposure to electrical
components, always follow the Electrical
LOCKOUT/TAGOUT Procedure. Disconnect
all circuits. Failure to comply can cause
property damage, injury or death.
To perform this operation, proceed as follows.
WARNING Disconnect the power supply
before replacing fuses.
1. Undo screws and remove side panel (A).
2. Open fuse-holder (B) and replace damaged fuse (C).
3. Replace fuse-holder and side panel when the
operation is complete.
C
B
CHANGING THE LAMP
WARNING Before performing any service
that involves electrical
disconnection and/or exposure to electrical
components, always follow the Electrical
LOCKOUT/TAGOUT Procedure. Disconnect
all circuits. Failure to comply can cause
property damage, injury or death.
46 Combination Oven Installation and Operation Manual
connection
A
connection
To perform this operation, proceed as follows.
WARNING Disconnect the power supply
or
before replacing lamps.
1. Loosen the screws of the lamp cover (A).
2. Remove the side panel (B)
3. Unscrew the screws to remove the lamp holder
(C).
4. Extract and replace the lamp (D).
WARNING During the procedure, take
care not to touch the lamp directly; wear
protective gloves if necessary.
or
5. Reassemble everything when the operation is
complete.
Note: the appliance wiring diagram location can be
found on the "Safety Lable and Sign Location" page.
A
B
D
C