Angelo Po AMERICA FX61 G 2 Manuel D'utilisation page 51

KEY TO ALARM TABLE (Continued)
Alarm Fault
The optional vacuum
E08
probe has failed or is not
properly connected
Maximum allowed
E09
temperature in chamber
exceeded
Electrical component
E10
compartment has
overheated
Electronic circuit board
E11
diagnostics tripped
E13
E14
Setup error
E20
The washing cycle has
E23
been interrupted during
the fi nal sanitization
stage
Automatic cleaning
E26
system failure
Valve has failed to close/
E28
open
Remedy
Press the "Reset" button
Contact an authorized service agent
The oven solves the problem on its own
Call an authorized service agent
Call an authorized service agent
Press the reset button and rinse the cooking
chamber thoroughly by hand.
Operate the oven in convection mode to dry
the cooking chamber.
Check that no residues of cleaning products
have been left inside the cooking chamber.
Rinse the cooking chamber by hand.
Press the "Reset" button
Combination Oven Installation and Operation Manual
Section 8
Troubleshooting
Notes
Disconnect and
reconnect the vacuum
probe before starting
the cooking cycle. If the
problem persists, call an
authorized service agent
The oven's functions are
disabled so no cooking
cycles can be performed
The oven's functions are
enabled; cooking cycles
can be performed
The oven's functions are
enabled; cooking cycles
can be performed
The oven's functions
are disabled; no cooking
cycles can be performed
If the problem persists,
call an authorized service
agent
If the problem persists,
call an authorized service
agent
The oven's functions
are enabled so cooking
cycles can be performed
Call an authorized
service agent
51