Angelo Po AMERICA FX61 G 2 Manuel D'utilisation page 45

REPLACING PARTS RECOMMENDATIONS
IMPORTANT _________________________
Before carrying
procedure, activate all safety devices
provided and decide whether staff at
work and those in the vicinity should be
informed. In particular, turn off gas and
water supply valves, cut off the electricity
supply to the appliance using the master
switch and prevent access to all devices
which might cause unexpected health and
safety hazards if turned on. If worn parts
have to be replaced, use original spare
parts only.
The manufacturer declines all responsibly
for injury or damage
due to the use of non-original parts, or
extraordinary work
which may modify the safety requirements
without the manufacturer's authorization.
When ordering components, follow the
instructions provided in the parts catalog.
WARNING Before performing any service
that involves electrical
disconnection and/or exposure to electrical
components, always follow the Electrical
LOCKOUT/TAGOUT Procedure. Disconnect
all circuits. Failure to comply can cause
property damage, injury or death.
WARNING Replacement operations must
be performed by an authorized service
agent in accordance with all relevant local
and legal requirements.
PARTS REPLACEMENT
out any replacement
to components
on the appliance
connection
REPLACEMENT OF THE BURNER
NOZZLE
To carry out this operation, proceed as follows:
1. Undo screws to remove side panel (A).
2. Disconnect gas supply line (B).
3. Remove injector (C) and replace it with one suitable
or
for the type of gas in use (see table below).
Gas type
FX61
Natural
Ø 635
gas
Ø 465
Propane
IMPORTANT _________________________
Take care to ensure that nozzle (C) is
correctly positioned (see diagram).
4. Reconnect pipe (B), replace panel (A) and
retighten screws when the operation is complete.
IMPORTANT _________________________
When the operation is complete light the
burner and check through the fl ame viewer
that the burner is operating correctly.
Combination Oven Installation and Operation Manual
Parts Replacement
Burner nozzle (mm/100)
FX101 FX82 FX122 FX201
Ø 605 Ø 635 Ø 615
Ø 485 Ø 485 Ø 500
Section 7
FX202
Ø 640 Ø 615
Ø 465 Ø 480
45