Publicité
Les langues disponibles
Les langues disponibles
C C o o v v e e r r r r e e p p l l a a c c e e m m e e n n t t
W W A A R R N N I I N N G G - - Do not wash the internal components of this support surface. Discard the support surface if a contamination is
found inside.
T T o o o o l l s s r r e e q q u u i i r r e e d d : :
•
None
P P r r o o c c e e d d u u r r e e : :
1. Unzip the cover.
2. Fold the top of the cover to the patient right side. Remove the foam crib assembly from the stretcher and set aside.
3. Discard the old cover.
4. Place the new cover, unzipped and open, on the frame with the gray bottom cover on the litter. Make sure the top cover
is folded over the patient right side of the stretcher.
5. Place the foam crib assembly on top of the bottom part of the cover. Make sure that the foam crib aligns with the cover.
6. Fold the top cover over the top of the foam crib assembly. Make sure that the top cover is aligned with the foam crib
assembly.
7. Zip the cover to close.
EN
12
1806-009-005 Rev AB.0
Publicité
