Publicité
Les langues disponibles
Les langues disponibles
Troubleshooting
Before requesting professional servicing, check all of the following points as well as connections and control
positions of all equipment connected to it. If the problem is not solved, or if there is a fault not shown in the table
below, contact your dealer.
Fault
WET Oriya
Remedy
Unit does not record or play cassettes
There is condensation inside unit.
Wait until the dew indicator goes out.
even though power is switched on.
Cassette holder does not close when a
Cassette tape is not properly loaded.
Load the cassette tape in the proper
cassette tape is loaded even if the
direction.
OPEN/CLOSE button is pressed.
No sound is output although tape is
Volume control on monitor amplifier is
Adjust volume using amplifier volume
running.
set at minimum.
control.
Monitor amplifier selector is set at a
Set the input selector position to either
position other than "DAT" or "TAPE".
"DAT" or "TAPE" depending on the
connections to the unit.
Noise or distortion is heard on playback.
Recording level was too high or toolow.
Record the tape again at the optimum
level.
Heads are dirty.
Clean the heads with a DAT cleaning
tape and record the tape again.
Cassette tape is worn out.
Use a new cassette tape.
Analog recording cannot be performed.
Accidental erasure prevention tab on
Close accidental erasure prevention tab.
cassette tape is open.
Unit is not connected properly to studio
Connect unit properly.
equipment.
REC LEVEL controls is set at "0".
Adjust recording (input) level with REC
LEVEL controls.
INPUT selector is set at the digital
Set the INPUT selector to the analog
position.
position.
Indexing cannot be performed.
Accidental erasure prevention tab oncas-
Close accidental erasure prevention tab.
sette tape is open.
Auto skip play cannot be performed.
SKIP PLAY CANCEL indicator is
Press SKIP PLAY CANCEL button to
illuminated.
turn off the indicator.
Digital signals cannot be recorded.
INPUT selector is set at the analog
Set the INPUT selector to the digital
position.
position.
Digital input/output connections on
Make proper digital input/output
rear of unit are not correct.
connections.
The type of digital input/output
Set the setting correctly referring
connections do not correspond with the _ to page E-41.
settings.
Search function does not operate
Start ID has not been recorded properly.
Record the Start ID, using the auto ID
properly.
.
:
function.
Program time is not displayed properly.
Program numbers have not been
Add serial numbers to recorded Start
recorded properly.
IDs.
Cassette tape has been inserted midway
Press REW/REV button and rewind to
through a program.
start of program.
Unit does not playback, record or
Unit was not operated in accordance
"Switch off power, and operate again
operate properly.
with instructions.
correctly in accordance with instruc-
tions.
oe
Publicité
