Publicité
Les langues disponibles
Les langues disponibles
System Display Mode Selection
Note:
Single play mode does not take effect during Program Play, such as when programming a random sequence
of selections using the program number and MEMORY buttons on the remote control.
When a Skip ID recorded is detected during playback:
Sequence
Operating mode
When the single play mode is off
| When the single play mode is on
of priority
(normal)
1
*Sub code editing
Playback continues.
Playback continues.
mode
2
'Skip play cancel
Playback continues.
PAUSE mode is established.
mode
3
Skip play mode
The tape advances to the next Start
The tapeadvances to thenext StartID
ID and playback mode is estab-
and pause mode is established.
lished.
When a Start ID recorded is detected during playback:
Sequence
Operating mode
When the single play mode is off
| When the single play mode is on
of priority
(normal)
1
*Sub code editing
Playback continues.
Playback continues.
mode
2
Other mode
Playback continues.
PAUSE mode is established.
Cancel mode
* Sub-code editing mode: refers to when the Start ID or Skip ID indicator is flashing after either of those buttons
has been pressed.
To change the setting:
Press the SETTING button (forward). The mode is switched alternately between on and off. The setting
established after initialization is "OFF".
Note:
Any ID recorded is ignored if it is detected during the first two seconds after playback starts.
Selecting the program playback blank skip mode (mode No.4)
Program playback blank skip determines which way the SV-4100 recognizes the end of a program. This is
necessary for program play since the machine must skip to a selection at another location on the tape when the
currently playing program ends.
When blank skip mode is on, the machine skips to the next programmed selection as soon as it encounters audio
level below -42 dB for 2 seconds or more. When blank skip mode is off, the machine skips to the next
programmed selection as soon as it encounters the next Start ID or Skip ID following the present program.
What is displayed
Actual display
Significance
The present program playback blank skip mode
1) PS-00
The program playback blank skip
setting appears on the counter display.
mode has been set to on.
2) PS---
The program playback blank skip
mode has been set to off.
To change the setting:
Press the SETTING button (forward). The mode is switched alternately between on and off. The setting
established after initialization is "ON".
Note: _ If the Start ID recorded is detected at the beginning of a blank section, the blank is not skipped until the
playback of the recorded section is completed.
E-4¢
Publicité
