Quick Start Function
ER
IN
OLIN
TI
ATS
ET
ITN
AE TE
SIO
LI
I
IE EI ECON IETS
EEL
EE GE EI EET
EE,
(1) One-time rehearsal playback (normal rehearsal)
In the trim mode (or during rehearsal playback), press the REHEARSAL button for a short duration (less than
1 sec.).
Each time the button is pressed, the tape is played back once (for 2 to 5 or so sec.) from the designated frame
position. The play indicator lights.
(2) Repeat rehearsal playback (repeat rehearsal)
In the trim mode (or during rehearsal playback), keep the REHEARSAL button depressed more than 1 sec.
The unit is placed in the repeat rehearsal mode, and the tape is played back repeatedly for about 1.5 sec. from
the quick start position. The play indicator lights.
To release repeat rehearsal:
When the REHEARSAL button is pressed for a short duration once during repeat rehearsal, the repeat rehearsal
mode is released and the unit returns to normal one-time rehearsal.
An example of trimming the quick start position during stop or playback:
The trimmed relative
[Display example of
frame value
a tape position]
New Quick Start
position advanced
50 frames from
initial point
Normal
Initial Quick
Time/PNO
4}
Start Position
4
4}
Display
STANOBWREREARSAL
SKIP/SETTING
STANDEVINEREARSAL
or SETTING
dial
About 5 seconds of the playback
Trim the quick start
The rehearsal playback
data before and after the current
position in frame
is commenced.
tape position is stored in the RAM.
increments.
To finely re-adjust the quick start position after rehearsal playback:
When the LOCATE LAST button is pressed while the unit is in Quick Start STANDBY mode, new data will be
stored in RAM. The tape position at the time of the button push becomes the center "00" point in trim mode.
(Refer to the section on the A-Time search.)
Starting the quick start
Press the PLAY button.
As soon as the button is pressed, playback commences from the set position. The quick start indicator stops
flashing and lights.
To terminate quick start:
Press the STOP button.
E-31