Publicité
Les langues disponibles
Les langues disponibles
E-42
System Display Mode Selection
Selecting the digital output mode (mode No.1)
What is displayed
Actual display
Significance
The output mode (format for commercial or con-
1) I
Format for consumer applications
sumer applications) of the digital output terminals
taken by coaxial and optical termi-
appears on the counter display.
nals.
According to standards, the coaxial and optical
2) IA
Format
for commercial applications
terminals are for IEC consumer use. The XLR, or
taken by coaxial and optical termi-
Cannon connectors are for AES/EBU professional
nals.
use. In order to increase compatibility with equip-
ment using non-strandard digital interfaces, this
3) AI
Format for consumer applications
display permits the format and interface connectors
taken by XLR-3 terminals.
to be interchanged. For example, AES/EBU may be
sent to the coaxial and optical connectors,while[EC
4) AA
Format for commercial applications
may be sent to the XLR connectors.
taken by XLR-3 terminals.
To change the setting:
Press the SETTING button (forward). The display changes in the sequence shown below, thus changing the
output format. The settings established after initialization are "II" for the coaxial and optical terminals and "AA"
for the XLR-3 terminals, which is the standard for IEC and AES/EBU.
Ge Ga -e
-
Selecting the error rate display (mode No.2)
What is displayed
Actual display
1) The total error rate for data playedbackbyhead
"A" and "B" light on the display.
The error rate is
A and head B appears on the counter display.
_ indicated by (the value displayed /9984).
2) The error rate for data played back by head A
Only "A" lights on the display. The error rate is indicated
appears on the counter display.
by (the value displayed / 4492).
3) The error rate for data played back by head B_ Only "B" lights on the display. The error rate is indicated
appears on the counter display.
by (the value displayed / 4492).
To change the setting:
Press the SETTING button (forward). The display changes in the sequence of 1) through 3) above.
Selecting the single play mode (mode No.3)
Single play is a function which suspends playback when a Skip ID or Start ID which has been recorded is detected
during playback.
Basically, when single play mode is on, the unit will playback normally until the next Start ID or Skip ID is
encountered. The tape will then "park" in PAUSE mode so the next selection is ready for playback at any time.
To resume playback, simply press the PLAY button.
What is displayed
Actual display
Significance
The present single play modesettingappearsonthe
1) SP---
The single play mode has been set
counter display.
to off.
2) SP-00
The single play mode has been set
to on.
The unit operates as follows depending on the operating mode.
Publicité
