Panasonic SV-4100 Mode D'emploi page 34

A-Time Search
No. Action taken Operation
3 Press the TIME MODE SELECT The flashing display of the digit to be set changes in the following
(FF) button. or gy sequence: "hour"-—>"minutes" "seconds" >" frames" "hour".
Press the TIME MODE SELECT The flashing display changes in the reverse direction:
(REW) button. or g "hour" frames"—>"seconds" "minutes" >"hour'
Press the MEMORY button on tne The flashing display of the digit to be set changes in the following
ie
remote control transmitter sequence: "hour"—>"minutes"—>"seconds" >" frames" "hour".
4 Repeat the above steps 2-3.
To suspend the input of A-Time:
Either press the STOP button or press the TIME INPUT button again. The deck is then placed in the stop mode.
Setting the time code:
Frame count Absolute time
4p The "hour" digit
f The "minutes" digit
co flashes. SKIP/SETTING REWREV FRICUE flashes.
(a)
(TIME MODE SELECT
or
SETTING dial
Place the unit Set the "hour" digit. Change the digit
in the time setting to be set.
mode.
Starting the A-Time search
Button Action taken Indicator
operated
PLAY button Timesettingiscompleted,and playbackcommences While the search is in progress, the play
beginning at the A-Time stored. indicator flashes.
STANDBY Time setting is completed, and the deckis placedin While the search is in progress, the
button the Quick Start STANDBY mode (the datais stored standby indicator flashes.
in the trim mode after the search is conducted). The A-Time stored will be at the center
"00" point of the trim range.
The PLAY or STANDBY button may be pressed even during search operation to select either mode upon
completion of the search.
E-34