Panasonic SV-4100 Mode D'emploi page 25

Indexing
RSC TS ASC SEN ARNT POE ETE IT PR IT ISIE BCI STE ES TOSS ILL IL TE ASTI ENTITLE CSET IIIT TLE STS
2) Manual recording
Note:
Shuttle search
pony
Press the START ID button. The start ID indicator flashes.
Repeat steps 1-2 to insert Start ID's one after another wherever desired.
Erasing Recorded Start ID's
Hint:
1
2
Press the START ID button. The start ID indicator flashes.
Turn the SHUTTLE SEARCH dial to run the tape to the point where you want to erase a start ID.
When the tape reaches the position at which a Start ID was recorded, the start ID indicator illuminates to show
the presence of a Start ID.
Press the ID ERASE button. The erase indicator illuminates.
Repeat steps 1-3 to erase subsequent ID's, if necessary.
If you wish to erase all Start ID's on a tape, it is best to start at the end of the tape. By default, the unit
searches for ID's in reverse direction during ID Erase mode.
Assigning Sequence Numbers to Recorded Start ID's
After recording or erasing of Start ID's and confirmation that all Start ID's are in the correct location, press the
RENUMBER button. The tape will rewind to the beginning, the unit searches for the recorded Start ID's, and
automatically assigns program numbers to them in sequence starting from 01. When the tape reaches the end,
the renumber function is complete, and the tape is rewound to the beginning again. While the tape is running,
the play indicator flashes. Each time the tape comes to a position where a Start ID has been recorded, the start
ID indicator illuminates.
E-25