Parkside PBRM 53 A1 Consignes D'utilisation page 22

13.3 Cleaning the V-belt (35)
(Fig. 23)
1. Tilt the lawnmower backwards.
2. Use a brush or compressed air to clean the V-belt
(35) after each use.
14 Transport
WARNING
Danger of injury and burning!
The product can start unexpectedly and cause injuries.
– Switch off the motor before carrying out any clean-
ing or maintenance work.
– Allow the motor to cool down.
– Disconnect the spark plug connector from the
spark plug.
– Remove the battery.
NOTE
For transport, the cutting height must always be set in
the highest position.
1. Empty the fuel tank using a petrol extraction pump
(not included in the scope of delivery) into a collec-
tion container.
2. Drain the motor oil of the warm motor.
3. Clean the cooling fins of the cylinder and the hous-
ing.
4. Fold in the top push bar (5) (see 15.3).
5. Wedge a few layers of corrugated cardboard be-
tween the upper (5) and lower push bars (9), and the
engine to prevent any chafing.
6. The product must be secured against tipping and
slipping during transport in vehicles in order to pre-
vent damage and injuries.
15 Storage
ATTENTION
Clean and maintain the product before storage.
ATTENTION
Do not store the product with the grass collection bas-
ket full. In hot weather, the grass begins to ferment
under heat. There is a risk of fire!
14 | GB / IE / NI / CY / MT
Store the product and its accessories in a dark, dry and
frost-free place that is inaccessible to children.
The optimum storage temperature is between 5°C and
30˚C.
Store the product in its original packaging.
Cover the product to protect it from dust or moisture.
Store the operating manual with the product.
• Never store the product with fuel in the tank inside a
building in which fuel vapours may come into con-
tact with naked flames or sparks.
• Allow the engine to cool down before parking the
product in enclosed spaces.
• In the event of prolonged storage, empty the fuel
tank with a fuel extraction pump (not included in the
scope of delivery).
• In order to avoid fire hazards, keep the engine, ex-
haust pipe and the area around the fuel tank free of
grass, leaves and leaking grease (oil).
15.1 Preparing the lawnmower for
long-term storage
WARNING
Do not remove the fuel in enclosed spaces, near fire
or when smoking. Petrol fumes can cause explosions
and fire.
1. Drain the fuel tank (13) with a fuel extraction pump
(not included) (see 16.4).
2. Carry out an oil change (see 16.3).
3. Remove the spark plug connector (17) from the
spark plug (17a). Remove the spark plug (17a) with
a spark plug wrench (not included in the scope of
delivery).
4. Fill the cylinder with approx. 20 ml of oil from an oil
can.
5. Pull the pull starter (26) slowly so that the oil protects
the inside of the cylinder.
6. Screw the spark plug (17a) back in.
7. Clean the cooling fins of the cylinder and the hous-
ing (see 13.1).
8. Be sure to clean the entire product to protect the
paint.
9. Store the product in a well-ventilated place.
15.2 Battery (28) and battery charger
(29)
Follow the safety instructions. and the notes regarding
charging and correct use, as specified in the operating
manual for your Parkside X 20 V Team range battery
(28) and battery charger (29). A detailed description of
the charging process and further information are pro-
vided in this separate operating manual.