Publicité
Les langues disponibles
Les langues disponibles
ATTENTION
Avoid damage to the product! Always actuate the
drive bow completely (until it reaches the stop) in or-
der to avoid subsequent damage to the transmission.
12.6.2
Switching the drive off
1. Release the drive bow (2). The drive is switched off
and the lawnmower stops.
2. The engine continues to run.
12.7 After mowing
• Always allow the engine to cool down before park-
ing the lawnmower in an enclosed space.
Remove grass, leaves, grease, and oil before stor-
age. Do not store other objects on the lawnmower.
• Check all screws and nuts before the next use. Tight-
en up loose screws.
• Empty the grass collection basket before the next
use.
• Please also observe the chapter "Storage".
13 Cleaning
WARNING
Danger of injury and burning!
The product can start unexpectedly and cause injuries.
–
Switch off the motor before carrying out any clean-
ing or maintenance work.
–
Allow the motor to cool down.
–
Disconnect the spark plug connector from the
spark plug.
–
Remove the battery.
WARNING
Health hazard!
Inhalation of fuel / lubricating oil vapours and exhaust
gases can cause serious damage to health, uncon-
sciousness and in extreme cases death.
–
Do not breathe fuel / lubricating oil vapours and
exhaust gases.
–
Operate the product outdoors only.
13.1 Cleaning the lawnmower (Fig. 1)
• Cleaning with a garden hose is only recommended
at low pressure. A high-pressure cleaner is not suit-
able for cleaning the product.
• Unhook the grass collection basket and brush it out
with a hand brush. You can also roughly clean the
housing of the lawnmower with the sweeper.
• For larger soiling, you can wipe the product with a
damp cloth.
NOTE
Before tilting the lawnmower, empty the fuel tank fully
using a fuel extraction pump (not included in the
scope of delivery).
Do not tilt the lawnmower beyond 90 degrees.
1. It is best to tilt the lawnmower backwards. Make sure
that the spark plug (17a) is pointing upwards. If the
spark plug (17a) points downwards, oil can leak out
and cause major damage to the engine and carbu-
rettor.
2. Alternatively, you can tilt the product on its side, but
you must make sure that the air filter cover (14) is on
the upper side.
3. Clean the underside of the lawnmower with a spatu-
la and hand brush. The spatula helps to remove
coarse and larger plant debris from the area of the
blade (30). Cleaning the underbody is easier and
more thorough immediately after use. Then dirt and
plant residues are still fresh and can be loosened
more easily.
4. If necessary and if the dirt is difficult to remove, you
can also use a special cleaner. Do not use aggres-
sive cleaning products such as cold cleaners or white
spirit.
5. Check that the grass ejection is clear of grass resi-
dues and remove these if necessary.
13.2 Cleaning the lawnmower via the
water connection (15)
(Fig. 1, 22)
NOTE
Push the spark plug connector onto the spark
plug properly again.
1. First remove the mulching insert (27) or the grass
collection basket (24).
2. For cleaning, connect a garden hose to the water
connection (15) via the built-in plug-in coupling.
3. Turn on the water and start the lawnmower (see
12.4).
4. The rotating blade (30) swirls the water.
5. After a few minutes, the lawnmower is free of all ad-
hering dirt and grass residues.
6. Allow the lawnmower to run for a short time without
water to remove most of the moisture through the
circulating air of the blade (30).
GB / IE / NI / CY / MT
|
13
Publicité
