Publicité
Les langues disponibles
Les langues disponibles
WARNING
Health hazard!
Inhalation of fuel / lubricating oil vapours and exhaust
gases can cause serious damage to health, uncon-
sciousness and in extreme cases death.
–
Do not breathe fuel / lubricating oil vapours and
exhaust gases.
–
Operate the product outdoors only.
ATTENTION
Product damage!
Using the product without or with too little engine and
gear oil can result in engine damage.
–
Fill with fuel and oil before commissioning. The
product is supplied without engine and gearbox
oil.
ATTENTION
Environmental damage!
Spilled oil can pollute the environment permanently.
The liquid is highly toxic and can quickly lead to water
pollution.
–
Fill/empty oil only on level, paved surfaces.
–
Use a filling nozzle or funnel.
–
Collect drained oil in a suitable container.
–
Wipe up spilled oil carefully immediately and dis-
pose of the cloth according to local regulations.
–
Dispose of oil as per local regulations.
ATTENTION
Risk of damage!
If incorrectly stored or undrained fuel is used, the car-
burettor may become clogged or engine operation
may be affected.
–
Put unused fuel in an airtight vessel and store it in
a dark, cool room.
Check before operation
• Check all sides of the engine for oil or fuel leaks.
• Check the engine oil level.
• Check the fuel level – the fuel tank should be at least
half-full.
• Check the condition of the air filter.
• Check the condition of the fuel lines.
• Make sure that the spark plug connector is attached
to the spark plug.
• Look for signs of damage.
• Check that all protective covers are in place and all
screws, nuts and bolts are tightened.
10.1 Filling up with engine oil
(Fig. 12)
ATTENTION
The product is delivered without engine oil.
Therefore, ensure that you add oil before starting
it up. Use multigrade oil (SAE 10W-30 or
10W-40) for this.
Check the oil level regularly before commissioning. An
oil level that is too low can damage the motor.
1. Place the lawnmower on a level, even surface.
2. Unscrew the oil dipstick (19).
3. Fill the tank with engine oil using a funnel (not in-
cluded in scope of delivery). Note the max. filling ca-
pacity of 0.4 l. Fill the oil up to the lower edge of the
filling nozzle carefully.
4. Wipe the oil dipstick (19) with a clean, lint-free cloth.
5. Reinsert the oil dipstick (19) and check the oil level
without screwing the oil dipstick (19) tight again.
6. The oil level must be within the middle mark on the
oil dipstick (19).
7. If the oil level is too low, add the recommended
amount of oil (max. 0.4 l).
8. Then screw the oil dipstick (19) in again.
10.2 Filling up with fuel (Fig. 13)
DANGER
Risk of fire and explosion!
When filling, fuel may ignite and even explode. This
can lead to severe burns or death.
• Switch off the engine and let it cool down.
• Keep heat, flames and sparks away.
• Only fill up with fuel outdoors.
• Wear protective gloves.
• Avoid contact with skin and eyes.
• Start the product at a distance of at least 3 m from
the fuel filling point.
• Watch out for leaks. If fuel is leaking, do not start the
engine.
ATTENTION
The product is delivered without fuel. It is
therefore essential to fill with fuel before
commissioning. Use Super E10 petrol for
this.
GB / IE / NI / CY / MT
|
9
Publicité
