cybelec DNC 1200 Informations Techniques page 11

.
•
•
GENERAL DESCR1PT10N
The CYBELEC numerical controls are specífically íntended for sheet metal
workíng machínes.
Depending on the software they wí11 be installed on press-brakes
(synchronized or not), foldíntg presses or tube bendíng machínes.
The machines equipped wíth these numeńcal controls are dangerous and are
subject to the Machine Directíves of the European Coınmuníty.
1t ís the responsíbílíty of the machine manufacturers to ensure that the safety
precautions relative to these machines are respected.
The numerical control ís not a safety device.
CYBELEC numerical controls are assímílated wíth programmable
automatons and are subject to the "Low voltage" (73/23/CEE) and
"Electromagnetíc Compatibílíty" (89/336/CEE) Directives, but are not
subject to the Machíne Dírectíves (89/392/CEE).
The CYBELEC numerícal controls conform wíth the above standards (see
Installation
ehapter).
TECHNICAL CHARACTERISTICS
The technical characteristícs of the numeńcal control can be found in the
document called CYBELEC DATA SHEET which ís aпііexed to this
document..
HANDLING, UNPACKING, STORAGE
CYBELEC numerical controls are delívered in a packaging destíned for
transport by traín, road or aír.
If the numerícal control has to be transported at a later date, ít must be packed
in the orígínal contaíner.
Storage characteristics
storage of the numerіca] control should be if possíble in the orígínal
container.
Temperature: - 25°C à + 55 °C
Humídíty: 10 % à 90 %
PAGE 3