Coltene SciCan BRAVO G4 Manuel D'utilisation page 85

17.4 SYSTEM ERRORS (CATEGORY S)
CODE ALARM DESCRIPTION
S001
Flash memory 1 on process board failed
S002 Flash memory 2 on process board failed
S005 USB key not accessible
S006
USB key not accessible
S007
USB key full
S009
Printer not connected or incompatible printer
Printer: there is no paper or there might be a
S010
configuration error
S011 Printer cover open
S012
Probable printer configuration error
S020
Cycle backup not done
S021
Cycle storage limit exceeded
Check, using a watchdog, that one of main
S030
tasks is not in crash condition
Check, using a hardware watchdog, that one
S031
peripheral is not in lock condition.
Check, using a watchdog, that one of main
S032
tasks is not in lock condition (e.g. infinite loop)
S034
SW malfunction
SW malfunction in solenoid valve
S035
management
S040 Check the log saving in the Flash memory
S042 Cycle performed with standard drying
S099 Error during cycle report creation
S100
SW malfunction
1 = OK (warning)
2 = OK + door unlocking + RESET
3 = Cycle failed + OK + door unlocking + RESET
MESSAGE ON THE DISPLAY
FLASH MEMORY
NOT ACCESSIBLE
CONTACT TECH. SERVICE
FLASH MEMORY
NOT ACCESSIBLE
CONTACT TECH. SERVICE
PROBLEM WITH USB KEY
CHANGE KEY
USB KEY
NOT ACCESSIBLE
CHANGE KEY
USB KEY FULL
CHANGE KEY
PRINTER DISCONNECTED
CHECK CONNECTION
PRINTER PAPER OUT
CHECK PAPER
PRINTER:
DOOR OPEN
PRINTER: NOT READY
TRY AGAIN
RUN BACKUP
DOWNLOAD NEW CYCLES
CYCLE MEMORY FULL
START OVERWRITING
SYSTEM ERROR
CONTACT TECH. SERVICE
SYSTEM
ERROR
CONTACT TECH. SERVICE
SYSTEM ERROR
CONTACT TECH. SERVICE
SYSTEM ERROR
CONTACT TECH. SERVICE
SYSTEM ERROR
CONTACT TECH. SERVICE
SYSTEM ERROR
CONTACT TECH. SERVICE
4-MINUTE STERILIZATION
COMPLETED
STANDARD DRYING
CHECK
LOAD DRYING
PROBLEM IN CREATING
CYCLE REPORT
CONTACT TECH. SERVICE
81
RESET MODE
2
2
2
2
2
2
2
2
2
2
2
2 (off-cycle)
3 (in cycle)
2 (off-cycle)
3 (in cycle)
2 (off-cycle)
3 (in cycle)
2
2
2 (off-cycle)
3 (in cycle)
1
1
2