Coltene SciCan BRAVO G4 Manuel D'utilisation page 48

11. USED WATER DRAIN
The unit is equipped with an internal waste water tank, that collects the drainage water after each cycle.
When the maximum water level is reached, a specific message is displayed.
Proceed with draining the water tank by following the instructions listed below.
Open the door and continue as follows:
1.
Prepare a basin with a capacity of at least 4
litres in proximity to the sterilizer; place the
free end of the drain tube provided in the
basin.
2.
Insert the other end of the tube in the female
union beneath the chamber inlet (connector
on the left) pushing down until you hear a
click.
3.
Completely empty out the tank and then press
on the upper part of the union to detach the
tube quick coupling.
Do not open the tank doors during the cycle execution in order to prevent hot water leaks or spurts.
The unit can be connected, directly, to the centralized draining point. (ref. paragraph 4.6)
Detaching the tube
44