Coltene SciCan BRAVO G4 Manuel D'utilisation page 93

–
TROUBLESHOOTING
CODE POSSIBLE CAUSE
Printer off.
Data cable not correctly connected
S009
to serial ports
RS-232.
No paper inside printer.
S010 Paper setting configuration not
correctly done.
S011 Printer lid open
S012
Printer not ready for use
Cycle back-up not done after 250
S020
cycles
Cycle storage limit exceeded after
S021
7000 cycles
S030 Malfunction of the control software
Malfunction of control board or
S031
software
S032
Malfunction of the control software
S034
Malfunction of the control software
Control software malfunction in
S035
solenoid valve management
S040 Malfunction of the control software
Malfunction of control board or
S041
control software
Malfunction of control board or
S042
software
Malfunction of control board or
S099
control software
Malfunction of control board or
S100
control software
SYSTEM ERRORS (CATEGORY S)
SUGGESTED SOLUTION
Make sure that printer is on.
Check correct connection of the printer cable.
Check printer compatibility.
If the problem persists, contact Technical Service (see Appendix).
Make sure that paper is correctly loaded.
Check correct connection of the printer cable.
Make sure that paper settings are correct.
If the problem persists, contact Technical Service (see Appendix).
Make sure that printer lid is correctly closed.
Check correct connection of the printer cable.
If the problem persists, contact Technical Service (see Appendix).
Make sure that paper is correctly loaded.
Check correct connection of the printer cable.
Make sure that paper settings are correct.
If the problem persists, contact Technical Service (see Appendix).
Perform cycle back-up.
See paragraph Sterilization cycle back-up.
If the problem persists, contact Technical Service (see Appendix).
Perform cycle back-up.
See paragraph Sterilization cycle back-up.
If the problem persists, contact Technical Service (see Appendix).
RESET according to the instructions.
Try restarting the program a second time.
If the problem persists, contact Technical Service (see the Appendix).
RESET according to the instructions.
Try restarting the program a second time.
If the problem persists, contact Technical Service (see the Appendix).
RESET according to the instructions.
Try restarting the program a second time.
If the problem persists, contact Technical Service (see the Appendix).
RESET according to the instructions.
Try restarting the program a second time.
If the problem persists, contact Technical Service (see the Appendix).
RESET according to the instructions.
Try restarting the program a second time.
If the problem persists, contact Technical Service (see the Appendix).
RESET according to the instructions.
Try restarting the program a second time.
If the problem persists, contact Technical Service (see the Appendix).
Contact Technical Service (see Appendix).
Contact Technical Service (see Appendix).
Try restarting the program a second time.
Try replacing the USB key.
If the problem persists, contact Technical Service (see the Appendix).
Contact Technical Service (see Appendix).
89
cont.